+=== 0^SHOW/MUF <prefix> [<hours>]^Show the likely propagation to a prefix
+This command allow you to estimate the likelyhood of you contacting
+a station with the prefix you have specified. The output assumes a modest
+power of 20dBW and receiver sensitivity of -123dBm (about 0.15muV/10dB SINAD)
+
+The command will display some header information detailing its
+assumptions, together with the locations, latitude and longitudes and
+bearings. It will then show UTC (UT), local time at the other end
+(LT), calculate the MUFs, Sun zenith angle at the midpoint of the path
+(Zen) and the likely signal strengths. Then for each frequency for which
+the system thinks there is a likelihood of a circuit it prints a value.
+
+The value is currently a likely S meter reading based on the conventional
+6dB / S point scale. If the value has a '+' appended it means that it is
+1/2 an S point stronger. If the value is preceeded by an 'm' it means that
+there is likely to be much fading and by an 's' that the signal is likely
+to be noisy.
+
+By default SHOW/MUF will show the next two hours worth of data. You
+can specify anything up to 24 hours worth of data by appending the no of
+hours required after the prefix. For example:-
+
+ SH/MUF W
+
+produces:
+
+ RxSens: -123 dBM SFI: 159 R: 193 Month: 10 Day: 21
+ Power : 20 dBW Distance: 6283 km Delay: 22.4 ms
+ Location Lat / Long Azim
+ East Dereham, Norfolk 52 41 N 0 57 E 47
+ United-States-W 43 0 N 87 54 W 299
+ UT LT MUF Zen 1.8 3.5 7.0 10.1 14.0 18.1 21.0 24.9 28.0 50.0
+ 18 23 11.5 -35 mS0+ mS2 S3
+ 19 0 11.2 -41 mS0+ mS2 S3
+
+indicating that you will have weak, fading circuits on top band and
+80m but usable signals on 40m (about S3).
+
+inputing:-
+
+ SH/MUF W 24
+
+will get you the above display, but with the next 24 hours worth of
+propagation data.
+