-<P>Ok, you should now have DXSpider running nicely and allowing connects by cluster nodes or users. However, it has to be shutdown and restarted manually and if connection scripts fail they have to be started again manually too, not much use if you are not at the console!
-So, in this section we will automate both. Firstly starting the cluster.
-<P>
-<H3>Autostarting the cluster</H3>
-
-<P>This is not only a way to start the cluster automatically, it also works as a watchdog, checking the sanity of DXSpider and respawning it should it crash for any reason.
-Before doing the following, shutdown the cluster as you did earlier.
-<P>
-<P>Login as root and bring up the /etc/inittab file in your favourite editor. Add the following lines to the file near the end ...
+<P>Cluster links in particular suffer greatly from the presence of telnet echo.
+This is caused by the telnet negotiation itself and can create at worst severe
+loops. At best it creates unnecessary bandwidth and large logfiles! There are
+things that can be done to limit this problem but will not always work dependent
+on the route taken to connect.
+<P>
+<P>Telnet echo itself should only be a problem if the connection is being made to
+the telnet port (23). This port uses special rules that include echo negotiation.
+If the connection is to a different port, such as 8000, this negotiation does
+not happen and therefore no echo should be present.
+<P>
+<P>Sometimes it is not possible to make a direct connection to another node and this
+can cause problems. There is a way of trying to suppress the telnet echo but
+this will not always work, unfortunately it is difficult to be more specific.
+Here is an example of what I mean ...