fixed set/obscount

[spider.git] / cmd / Commands_en.hlp

diff --git a/cmd/Commands_en.hlp b/cmd/Commands_en.hlp
index 463d55e8800766b2d9716de66c3ff70accd963bd..1cd2b30f664ff0087f2b66b97b19cecd01400ee3 100644 (file)
--- a/cmd/Commands_en.hlp
+++ b/cmd/Commands_en.hlp
@@ -1053,6 +1053,10 @@ If a ping is heard then the obscount is reset to the full value. Using
 default values, if a node has not responded to a ping within 15 minutes,
 it is disconnected.
 
+You can set this parameter between 1 and 9.
+
+It is STRONGLY recommended that you don't change the default.
+
 === 0^SET/PAGE <lines per page>^Set the lines per page
 Tell the system how many lines you wish on a page when the number of line
 of output from a command is more than this. The default is 20. Setting it
@@ -1069,13 +1073,29 @@ affect routing decisions. The default interval is 300 secs or 5 minutes.
 
 You can use this command to set a different interval. Please don't. 
 
-But if you do the value you enter is treated as minutes up 60 and seconds
+But if you do the value you enter is treated as minutes up 30 and seconds
 for numbers greater than that.
 
 This is used also to help determine when a link is down at the far end
 (as certain cluster software doesn't always notice), see SET/OBSCOUNT
 for more information.
 
+If you must change it (and it may be useful for internet connected nodes
+on dynamic IP addresses that go away after a set time of usage) the time
+can be specified as:-
+
+  5      which if less than 30 is converted to minutes otherwise is 
+         taken as the no of seconds between pings. 
+  120s   120 seconds
+  5m     5 minutes
+  1h     1 hour
+
+Please be aware that this causes traffic to occur on the link, setting 
+this value too low may annoy your neighbours beyond the point of 
+endurance!
+
+You can switch this off by setting it to 0.
+
 === 9^SET/PRIVILEGE <n> <call> [<call..]^Set privilege level on a call
 Set the privilege level on a callsign. The privilege levels that pertain
 to commands are as default:-
@@ -1348,7 +1368,7 @@ and returns any information available for that callsign. This service
 is provided for users of this software by http://www.qrz.com 
 
 === 0^SHOW/ROUTE <callsign> ...^Show the route to the callsign
-This command allows you to see which node the callsigns specified are
+This command allows you to see to which node the callsigns specified are
 connected. It is a sort of inverse sh/config.
 
 sh/route n2tly