eg:-
SET/HOMENODE gb7djk
-=== 8^SET/HOPS <call> ann|spots|wwv|wcy <n>^Set hop count
+=== 8^SET/HOPS <call> ann|spots|route|wwv|wcy <n>^Set hop count
Set the hop count for a particular type of broadcast for a node.
This command allows you to set up special hop counts for a node
=== 0^SHOW/HFTABLE^Show the HF DX Spotter Table for your country
Show the HF DX Spotter table for your country for the last 31 days
-=== 8^SHOW/HOPS <call> [ann|spots|wcy|wwv]^Show the hop counts for a node
+=== 8^SHOW/HOPS <call> [ann|spots|route|wcy|wwv]^Show the hop counts for a node
This command shows the hop counts set up for a node. You can specify
which category you want to see. If you leave the category out then
all the categories will be listed.
SH/MOON
SH/MOON G1TLH W5UN
+You can also use this command to see into the past or the future, so
+if you want to see yesterday's times then do:-
+
+ SH/MOON -1
+
+or in three days time:-
+
+ SH/MOON +3 W9
+
=== 0^SHOW/MUF <prefix> [<hours>][long]^Show the likely propagation to a prefix
This command allow you to estimate the likelihood of you contacting
a station with the prefix you have specified. The output assumes a modest
should be noted that the figures will probably not be very useful, nor
terrible accurate, but it is included for completeness.
+=== 0^SHOW/NEWCONFIGURATION [<node>]^Show all the nodes and users visible
+This command allows you to see all the users that can be seen
+and the nodes to which they are connected.
+
+This command produces essentially the same information as
+SHOW/CONFIGURATION except that it shows all the duplication of
+any routes that might be present It also uses a different format
+which may not take up quite as much space if you don't have any
+loops.
+
+BE WARNED: the list that is returned can be VERY long
+
+=== 0^SHOW/NEWCONFIGURATION/NODE^Show all the nodes connected locally
+Show all the nodes connected to this node in the new format.
+
=== 1^SHOW/NODE [<callsign> ...]^Show the type and version number of nodes
Show the type and version (if connected) of the nodes specified on the
command line. If no callsigns are specified then a sorted list of all
If no callsign is given then show the information for yourself.
-=== 0^SHOW/SUN [<prefix>|<callsign>]^Show sun rise and set times
+=== 0^SHOW/SUN [+/- days][<prefix>|<callsign>]^Show sun rise and set times
Show the sun rise and set times for a (list of) prefixes or callsigns,
together with the azimuth and elevation of the sun currently at those
locations.
SH/SUN
SH/SUN G1TLH K9CW ZS
+You can also use this command to see into the past or the future, so
+if you want to see yesterday's times then do:-
+
+ SH/SUN -1
+
+or in three days time:-
+
+ SH/SUN +3 W9
+
=== 0^SHOW/TIME [<prefix>|<callsign>]^Show the local time
If no prefixes or callsigns are given then this command returns the local
time and UTC as the computer has it right now. If you give some prefixes