enhanced load/keps to accept a message no. This will create a new keps

[spider.git] / cmd / Commands_en.hlp

diff --git a/cmd/Commands_en.hlp b/cmd/Commands_en.hlp
index 8e9d381713cba06d11b62034e6a7458d1158696a..cb99b9d1a3aa9a65a835dfb8cf7fd74979dfe62b 100644 (file)
--- a/cmd/Commands_en.hlp
+++ b/cmd/Commands_en.hlp
@@ -766,6 +766,20 @@ was just after a cluster restart.
 Reload the /spider/msg/forward.pl file if you have changed it
 manually whilst the cluster is running.
 
+=== 5^LOAD/KEPS^Load new keps data
+=== 5^LOAD/KEPS [nn]^Load new keps data from message
+If there is no message number then reload the current Keps data from
+the Keps.pm data file. You create this file by running 
+
+ /spider/perl/convkeps.pl <filename>
+
+on a file containing NASA 2 line keps as a message issued by AMSAT. 
+
+If there is a message number, then it will take the message, run
+convkeps.pl on it and then load the data, all in one step.
+
+These messages are sent to ALL by GB7DJK (and others) from time to time. 
+
 === 9^LOAD/MESSAGES^Reload the system messages file
 If you change the /spider/perl/Messages file (usually whilst
 fiddling/writing new commands) you can have them take effect during a
@@ -1238,6 +1252,7 @@ eg:-
   SET/HOMENODE gb7djk
 
 === 8^SET/HOPS <call> ann|spots|route|wwv|wcy <n>^Set hop count  
+=== 8^UNSET/HOPS <call> ann|spots|route|wwv|wcy^Unset hop count  
 Set the hop count for a particular type of broadcast for a node.
 
 This command allows you to set up special hop counts for a node 
@@ -1250,6 +1265,12 @@ eg:
 Set SHOW/HOPS for information on what is already set. This command
 creates a filter and works in conjunction with the filter system. 
 
+You can unset the hops with command UNSET/HOPS. For example:-
+
+  unset/hops gb7djk ann
+  unset/hops gb7mbc spots
+
+
 === 9^SET/ISOLATE^Isolate a node from the rest of the network
 Connect a node to your system in such a way that you are a full protocol
 member of its network and can see all spots on it, but nothing either leaks
@@ -1262,7 +1283,8 @@ Remove isolation from a node - SET/ISOLATE
 
 === 0^SET/LANGUAGE <lang>^Set the language you want to use
 You can select the language that you want the cluster to use. Currently
-the languages available are en (english) and nl (dutch).
+the languages available are en (English), de (German), es (Spanish) 
+and nl (Dutch).
 
 === 0^SET/LOCATION <lat & long>^Set your latitude and longitude
 === 9^SET/SYS_LOCATION <lat & long>^Set your cluster latitude and longitude