</CODE></BLOCKQUOTE>
<P>The first of our three examples would output something like this,
<P>
+<BLOCKQUOTE><CODE>
<PRE>
sh/c
Node Callsigns
GB7DXM G1EUC G3GAF G3LAS G4ZTR G8WXU
M0BCT M1EMF
</PRE>
+</CODE></BLOCKQUOTE>
<P>You will notice that EI5TCR is showing only that it has 7 users and not
giving the actual callsigns. This means that this node is on a limited
protocol of some kind, probably because of a contest situation where
<P>The second example would just show the nodes connected in the
network, like this,
<P>
+<BLOCKQUOTE><CODE>
<PRE>
sh/c/n
Node Callsigns
PA4AB-14 PA4AB-14
PI4TUE-8 PI4TUE-8
</PRE>
+</CODE></BLOCKQUOTE>
<P>If we insert the node_call pi4tue-8 into the third example, then
this would be the output,
<P>
+<BLOCKQUOTE><CODE>
<PRE>
Node Callsigns
PI4TUE-8 9A1CMA-6 DF6PW DL4FAY DL4KAK DL4WF-2
PA0RCT PA3DYS PA3FDO PA5KW-4 PI4TUE-9
YT1XX
</PRE>
+</CODE></BLOCKQUOTE>
<P>As you can see, only the users of the requested node are shown.
<P>You can also use a prefix to show only a group of nodes. For example
you may only wish to see who is connected to the nodes in the UK. To
</CODE></BLOCKQUOTE>
<P>The output of this command would look like this,
<P>
+<BLOCKQUOTE><CODE>
<PRE>
Callsigns connected to GB7MBC
G0JHC G0NEI G0VGS G0VGS-2 G0YLM
G3JAG G3OWO G3UEU
</PRE>
+</CODE></BLOCKQUOTE>
<P>
<HR>
<A HREF="usermanual-8.html">Next</A>