X-Git-Url: http://dxcluster.org/gitweb/gitweb.cgi?a=blobdiff_plain;ds=sidebyside;f=sgml%2Finstallation.sgml;h=7f4e739879c47aa6c9d364a75417d764117bc42c;hb=043b4f98b5b8d96b1b2dd5016fca05d950d5c06f;hp=086cdb3883431bfcad47e26127bfa96b14ce7c0e;hpb=18a88cbe1dd85e01e6ee403505bf9571d260d315;p=spider.git diff --git a/sgml/installation.sgml b/sgml/installation.sgml index 086cdb38..7f4e7398 100644 --- a/sgml/installation.sgml +++ b/sgml/installation.sgml @@ -4,10 +4,10 @@ -
-This section describes the installation of DX Spider v1.47 on a
+This section describes the installation of DX Spider v1.50 on a
I am assuming a general knowledge of Linux and its commands. You should
@@ -43,7 +40,7 @@ in the development of Spider.
In addition to the standard Red Hat distribution you will require the
-following modules from
@@ -108,6 +106,13 @@ Log in as 'root', and make sure you're at '/root' before you continue. Here are
# make test
# make install
# cd ..
+#
+# tar xvfz /usr/local/packages/Digest-SHA1-2.01.tar.gz
+# cd Digest-SHA1-2.01
+# perl Makefile.PL
+# make test
+# make install
+# cd ..
@@ -120,7 +125,7 @@ nearly are! Pay particular attention to the instructions of IO, above.
I will assume that you have already downloaded the latest tarball of
the DXSpider software and are ready to install it. I am assuming version
-1.47 for this section but of course you would use the latest version.
+1.50 for this section but of course you would use the latest version.
Login as root and create a user to run the cluster under.
-For SUSE distributions, the command would be ..
+For SuSE distributions, the command would be ..
+NB: The AX25 stuff in 2.4 kernels appears to have been broken until 2.4.18. I
+strongly suggest you get at least this kernel.
+
For 2.4 kernels you need these files...
@@ -1312,7 +1321,7 @@ DX:3:respawn:/bin/su -c "/usr/bin/perl -w /spider/perl/cluster.pl" sysop >/dev/t
This line works fine for RedHat distributions. It is also fine for SuSE up to
-7.0. From Suse 7.1 you need to add runlevels 2 and 5 like this ...
+7.0. From SuSE 7.1 you need to add runlevels 2 and 5 like this ...
+NB: It should be noted that /dev/tty7 is only an example. Some SuSE systems will
+only accept upto tty6. It really does not matter which tty you run it on.
+
As root type the command telinit q. DXSpider should start up
immediately. You will see the output on tty7 and if you login as sysop